SD Card Problem

[DoubleK]

Hi my problem is that i cannot print from sd card without computer. On the panel i see the file, after enter the display shows me it is printig but it do nothing. I have a sandisc sdhc 4gb card. Is this the problem from the sd card or is the problem the sd card reader?

[bang]

I guess it is the SD card...
All the .gcode files in the card have the same problem?
Did the bed and extruder heat up after you clicked on the file?

[DoubleK]

No the bed and the extruder did not heat after i start the print job

[bang]

No the bed and the extruder did not heat after i start the print job

So all of your files in the card had the same results?
Did you check the gcode of the problematic file?
Was it OK?

[DoubleK]

Found the failure, i saved the files on the sd card with binaryformat for repetier firmware and then printer say wait for user and do nothing. I must disable this option and then it works.But when the printjob is longer as 2 hours it stopped without no message . Post can be closed, thank you.