M201 board firmware(DUAL HEAD)

[syossi2]

This is my topic
The B board has normal usb port


I think its the same firmware also for the ver A
But its on your risk

Since there is no support fot my unick firmware


Yossi

[Hefestis]

I am trying to convert to a dual head on my mixing prusa m201 i have the gtm32 board with the micro usbport. . i have replaced the mixing head and wired into the proper places on my gtm 32 mother board which has locations for 3 extruders and thermisters, but it seems i need a firmware change to allow this. i have read through the thread here is the firmware file several messages above the one i need to do this? any help would be greatly apreciated

[syossi2]

Please serch the spicieal fw in the forum
I post it somewhere fro the regular usmaybe it will be also ok for the micro usb
Buy its on your risk