Rusted extruder bearings

[Fred-D]

Hi,

I got my Mecreator 2 printer on the 2nd of December and once I solved some problems, I saw this:

bearing.jpg (641.79 KiB) Viewed 6125 times

One of the bearings was not correctly attached but there is also some rust on the left one.

I corrected the problem on the right.

Can I reasonably ask Geeetech to send me a new part as the problem was not seen during the final quality check?

Thanks for any reaction and/or answer

FRED

[William]

Maybe you can contact the seller to talk about it...It should be replaced i guess if you have verified it..

[Fred-D]

Hi William,

Thanks for your answer.

I'm going to request 2 new extruder bearings as they are rusted.

[William]

Sounds nice..i guess you'll get them soon.