My slicer settings

[zhangxueyou]

I use Geeetech Prusa i3B, with 1.75mm filament and 0.3mm diameter. Slicer software is Slic3r. Attachment is my slicer settings, I got good print with these settings, you can try.
Actually, anyone who uses different kinds of printer, or the same printer with different filament diameter or nozzle diameter, can also refer to this setting. But you have to change some parameters in slic3r, including "filament diameter", "nozzle diameter", "first layer height"(it is as same as nozzle diameter), "other layers height"(I suggest lower than first layer for 0.05-0.1mm).

slicer settings(1.75mm-0.3mm).zip

(388.83 KiB) Downloaded 2122 times

[zhangxueyou]

You can also load the configuration file directly.

import slicer setting 1.png (46.16 KiB) Viewed 41472 times

Open slic3r in Repetier Host:

import slicer setting 2.png (52.58 KiB) Viewed 41472 times

import slicer setting 3.png (87.36 KiB) Viewed 41472 times

slicer config.zip

(1.27 KiB) Downloaded 1762 times

[johnz]

What speed on the feed rate and flow rate??

[zhangxueyou]

What speed on the feed rate and flow rate??

1 or 1.1 maybe.

[johnz]

Ok how about on the Repetier v1.0.6

[zhangxueyou]

Ok how about on the Repetier v1.0.6

I use Repetier1.0.6 exactly. And I use the slicer settings as the attachment above, and it prints fine.

[thhale]

Thanks for sharing.

[gpau]

Hi,
where I find the slicer setting for mac Ios?

Thank you

[Cup]

@gpau
So the Mac version doesn't recoganize the .ini format file?

[gpau]

@cup
ok,
I can get it for windows
thanks