I have just assembled the Geeetech G2s mini and uploaded the firmware but when i try to start power up the printer, it shows ( Err: MIN TEMP).
Could it be that the port at the controller board for the print bed is faulty? If so, will Geeetech send me a replacement board?
err msg: min Temp
Re: err msg: min Temp
Hi,
You can refer to this post to make some troubleshooting:
http://www.geeetech.com/forum/viewtopic ... 23&t=17030
You can refer to this post to make some troubleshooting:
http://www.geeetech.com/forum/viewtopic ... 23&t=17030
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!