Z AXIS BLOCKED in one direction

Post by **William** » Mon Oct 10, 2016 5:17 pm

Then plug Z motors into X/Y motor's slot on the board to see how Z motors go.

Pierfrancesco · Post by **Pierfrancesco** » Mon Oct 10, 2016 6:21 pm

Yes... In X,Y slots Z motors works fine... Separatly but in both direction

Pierfrancesco · Post by **Pierfrancesco** » Tue Oct 11, 2016 3:08 pm

I think that the board is defected, how Can I get another One ?

Post by **William** » Tue Oct 11, 2016 4:11 pm

Hi,
Take some clear photos of your board's back and front,i wanna see if there is a bad soldering at the "DIR" pin of Z axis.

Pierfrancesco · Post by **Pierfrancesco** » Wed Oct 12, 2016 12:59 am

Post by **William** » Wed Oct 12, 2016 5:24 pm

Pierfrancesco wrote:

You can try soldering this spot in the picture again if you have a tool.

PS.Did you try reflashing the firmware for Pro B?

Pierfrancesco · Post by **Pierfrancesco** » Wed Oct 12, 2016 5:45 pm

I will try to solder... Yes, I reflashed firmware many times

Pierfrancesco · Post by **Pierfrancesco** » Wed Oct 12, 2016 9:26 pm

Nothing happened, always the same...

Post by **William** » Sat Oct 15, 2016 4:28 pm

Try the new board when it arrives,and update this post plz.

Pierfrancesco · Post by **Pierfrancesco** » Sat Oct 15, 2016 4:35 pm

Thank you man

Geeetech