Hi, I already maunted the printer and I started to try moving the printhead through the three axes. The X (left-right) axis is OK, and so is the Z (up-down) axis. But the Y (front-back) axis moves only in one direction, that is it can move only forward, but it doesn't accept any backwards move. What can I do? There's something wrong in the stepper motor o the motor drive?
Thanks,
Sergio Internicola
One way Y axis stepper motor.
Re: One way Y axis stepper motor.
Hi,
I think you'd better have a double check on your Y endstop's installation,and you may wanna read this post:
http://www.geeetech.com/forum/viewtopic ... 18&t=17883
I think you'd better have a double check on your Y endstop's installation,and you may wanna read this post:
http://www.geeetech.com/forum/viewtopic ... 18&t=17883
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!