Hi All
thought this would be the best place to start. On my current printers that we use the RAMPS 1.4 and ATMega2560 we have auto leveling setup with an induction sensor which is pretty simple as we use a metal plate and marlin firmware has it all in there.
I am wondering how would i go about setting up Auto leveling with an induction sensor replacing the Zstop on the M201 with the GTM32 control board. Is this possible?
Thanks for any advice and / or help
Kindly
Auto Leveling on Geeetech M201
Re: Auto Leveling on Geeetech M201
Just curious if anything has come about with this issue?
Re: Auto Leveling on Geeetech M201
i'm afraid not.As far as i know,the M201's board GTM32 is not open source...
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Auto Leveling on Geeetech M201
Unfortunately noone has replied nor given me any extra information.
Im looking at removing the GTM32 Board as it not that great for the flexibility i need
replace it easily with a RAMPS 1.4 running marlin
which wills support the bedsize, auto bed tramming with induction sensor and multi nozzle extrsuion which is what we run on all our other printers now
Im looking at removing the GTM32 Board as it not that great for the flexibility i need
replace it easily with a RAMPS 1.4 running marlin
which wills support the bedsize, auto bed tramming with induction sensor and multi nozzle extrsuion which is what we run on all our other printers now