Missing Heat Wire Connectors

[socalborn]

Almost completed the assembly and ran into a problem. There seems to be connectors that connects to the heating wires for the extruder and the bed and then you connect them to the control board. I've looked everywhere and I cannot find them. can I solder them directly or what?

[Admin]

yes, there should be 3 green connectors which can be removed, are they missing?
can you post a clear picture of the green part of the board?

[socalborn]

I did post a clear picture of the green portion.

[Admin]

I did post a clear picture of the green portion.

please contact the sellers to send you the replacement.