M201 firmware - supported GCODE command list

[stado65]

Hi Mark,

Could you give us an ETA for the M201 firmware update taking into account (some of) our requests regarding GCode support ?
Thanks

[Mark]

I just asked the engineer, might need you guys to wait for about two weeks, maybe the end of this month, hope you can understand.

[stado65]

OK, thanks for your quick answer.

[Mark]

the firmware has been updated to V1.0.5, just added some gcode commands, the other ones will be added later:
M92: Set axis_steps_per_unit
M110: Set Current Line Number M500
M502: Revert to the default "factory settings."
M300: Play beep sound
M304: Set PID parameters - Bed

[stado65]

Hi Mark,

Perfect !
Will try this ASAP

[stado65]

The 1.0.5 firmware is a real improvement. The printer works flawlessly with Octopi now.
You did a great job, thx !

[cerealkillers]

Is there any chance the PID tuning commands will be implemented?

M301 - Set PID values
M303 - PID tuning
M500 - Save