Prusa I3X: Mount Belt Driving Wheel

[novos3lic]

Hy to all..I'm mounting the belt driving wheel of the Prusa I3x...i've noticed that, in the guide, the required part to mount the two pieces, are this:

- 3x M3 X 20 mm screw (see attach Screen_1)

But at the end, in the video and in the guide, it's mentioned that, to mount one oh the piece, i'll use an M3 x 40 (Screen_2), that's not included..

Also i want to say that the driven wheel holder, it's very narrow and doesn't allow the wheel from turning..

[Mark]

use the M3*40 one, not the shorter one. And the driven wheel, try to lubricate it or expend it a little.

[novos3lic]

Thanks for the reply..ok i'll use the M3x40..The problem is that is not included in the package, so i would like to inform other buyers.
For the driven wheel, obviously i expand it a little.