Board problems
Board problems
I just received a GT2560 board, and after connecting it all up, I find a few problems with it, mainly the motors. They are only working one way, sort of. I have run out of ideas, The printer was working fine with the Ramps 1.4 and arduino mega 2560, so I know the motors and drivers are ok. Maybe there are some software settings I need.
Re: Board problems
did you home the printer? If you didn't do that then all the axis will only go towards one way.
Re: Board problems
Thanks Mark, but not quite sure what you mean by homing the printer, I am pretty new to this..Mark wrote:did you home the printer? If you didn't do that then all the axis will only go towards one way.
Ernie
Re: Board problems
when you use the repetier host, click the "house"button then all the axis will home to the endstop position.