firmware for Geeetech Prusa I3 M201

[rogue88]

Hello, friends.
I need a firmware for Geeetech Prusa I3 M201, GTM32.
Thank You

P.P. kto@progress-sz.com

[Mark]

download it here:
http://www.geeetech.com/forum/viewtopic ... 162#p28162

[rogue88]

Thank You, the firmware is updatet.
But!
I have installed Repetier Host 0.9 and 1.6 and a couple of drivers. The printer can not be seen.
Other problem that I have is with positioning x and y.
Please help

[Mark]

have you tried the FTDI driver? is the same as the GT2560.
you can download it here:
http://www.geeetech.com/wiki/index.php/ ... he_drivers

[rogue88]

Yes, I am with this driver. When I connect usb cable of the printer, It connects to COM6.
If I try in Repetier Host another Com, It gives a mistake.
When I connect Com6, it says nothing, but I can not move , nothing. It looks like as not connected.
What can I do?

[Mark]

the baud rate is 115200 and the receive cache size is 63, did you set it correct?

[rogue88]

Yes, It shows only, that 6-7-14 commands waiting.
This is down in the middle.
Any advice?

[Mark]

does your LCD working? how about other baud rate?

[rogue88]

Yes, LCD works. I have tried all the rate untill 230400. Nothing happens.

[rogue88]

So I have succeed to start the printer with Repetier Host 1.6.
But I still have a problem with Xo and Yo.
The second problem ist with the extruder heater. He wouldn't start? Why?