Delta Rostock mini G2s Extruder drives Axial motors

[divtec]

I am having the same problem when trying to us both extruders.

Is the firmware fixed yet. I just downloaded and uploaded the November Firmware... but, dual extruder problem is still there.

When can we expect a fix?

FYI: I purchased my G2s back in July 2015, I really like it. Took a bit to get it to work correctly... but, it does perform very well.

Thanks is advance...

[Mark]

have you checked the firmware here?
http://www.geeetech.com/forum/viewtopic ... 13&t=17064

[divtec]

Yes this is the Firmware I compiled and uploaded to my G2s... the problem is still there.

[Mark]

which one did you download? and your printer is G2S or G2S pro? I'll test it with my G2S pro.

[divtec]

I downloaded G2s for the plastic G2s machine... NOT the firmware for the metal version G2s.

[Mark]

Sorry the version for the plastic one is the wrong one, but the metal one is the correct one, now we have updated it, please check it agian, tks!

[divtec]

Ok... to clarify... you said that you "updated" it.

Does that mean that I should use the one for the plastic machine again... since it's been updated...
or should I download the one for the metal machine and use it?

Please be specific.

[Mark]

yes choose the one for your plastic G2S, I have replaced the old firmware with the new version.

[thebatfink]

Hi. Today I also have started to see this behaviour after some time of no issues printing.

I have metal G2S Pro and currently only using extruder 1 (2 is not in use).

When hitting manual extrude in repetier all 3 axis begin to move up and no extrusion occurs. I have re-downloaded the firmware and see no difference, all axis still move when trying to extrude??

[Mark]

did you home the printer before move the extruder? if not then it will behave like this.