X Axis moving only in one direction

brisrascal · Post by **brisrascal** » Sat Nov 14, 2015 9:35 pm

I have a problem with my x axis on my Me Creator moving only in one direction. I tried the following using the Repetier Host V1.5.6:

X Axis
X Axis endstop: Tried M119, found to be triggered and traced it to a disconnected lead (Fixed)

Y Axis
The Y axis movement stops in the middle of the printer. Does not seem to move beyond a set point of the machine.

Can you advise me as to how to resolve the problem?

Mark · Post by **Mark** » Mon Nov 16, 2015 6:04 pm

the Y axis, is your printer settings correct?

brisrascal · Post by **brisrascal** » Mon Nov 16, 2015 7:34 pm

Hi,

Isn't the heatbed 150 by 150? I have addressed the Y axis problem which is due to a disconnected endstop.

Mark · Post by **Mark** » Tue Nov 17, 2015 9:50 pm

If your printer is prusa I3, then I remember it is 200*200.

Geeetech

X Axis moving only in one direction

X Axis moving only in one direction

Re: X Axis moving only in one direction

Re: X Axis moving only in one direction

Re: X Axis moving only in one direction