Can anyone help me get the original firmware?

[jlgale]

I am using the GT2560 board on my I3. The original firmware was working great on it but by me playing around I messed it up without having a backup which was my fault. does anyone have the original firmware that they can send me? Thank you

[Mark]

what's your printer type?

[jlgale]

Acrylic Geeetech I3 pro 3D printer DIY kit

[Mark]

Pro B ,pro C or pro X?

[jlgale]

thank you all that have sent me the firmware. you all have been a big help

[alexbkk19]

Dear all,

I have the same issue, I used a wrong firmware and now my printer dosen't respond. I have only black squares on the screen. (I hope it's not damaged)

Can you please send me the original firmware ?
I'm using the prusaI3 pro X

Thanks a lot

[Mark]

http://www.geeetech.com/forum/viewtopic ... 10&t=17046
Hi guys, download it here.

[TTMighty]

I attempted the "Marlin-PI3_Pro_B" download for my Acrylic Prusa I3 B, and it did not work. I am running the Arduino Mega2560 with Ramps1.4 board. Is it confirmed that this is the correct firmware for that one?

[Mark]

you should download this one: I3 pro&proB(ramps) , that one is for GT2560.

[TTMighty]

Mark; You said "you should download this one: I3 pro&proB(ramps) , that one is for GT2560."

When I download that one, there is no *.ino file in the archive. Is the rar file complete?

Thanks in advance.