FAQ

[fotomickey]

I'll be interest to see a post video show how to disassemble Hot-head after usage too. My experience its impossible to dissemble after used (glued in). It is very frustrated process for me Thanks

[Sandcrab3]

No one has an answer for this. If not a video, a step by step procedure. I know that Geetech must know how this is done, even if the farm out the process for their assembled parts.

[Mark]

Hi, guys , maybe you can find it here:
https://www.youtube.com/results?search_ ... 8%E7%A5%A5

[fotomickey]

As mentioned on the post, I want to see how the hotends disassemble after being used, it seem there are design faluse the hotends cannot deassemble after used. is It became 1 time use hotend. Please show a new video on use hotends to enlighten me if assumed wrong

Thanks

[Mark]

you can refer to the picture bellow:

[fotomickey]

Hi Mark, what about Delta Hotends, please show new video

[Mark]

They are the same ones.

[fotomickey]

Hi Mark

Please verify the design , Delta used J head which has heat resistance barrel, that is nothing in common with above picture.

[Mark]

You mean the PEEK one, right? I suggest do not disassemble the PEEK Jhead, it's hard to make it work agian..

[fotomickey]

Hi Mark

Then you confirm J head is dead once clogged. What sort of solutions/ options left for G2 delta. ? Please advise