Mightyboard Rev E wrong power connector

[Mark]

Hi, I don't see the pic here, have you post it ?

[Mark]

The voltage range of mightyboard is 12V-24V. Do you have pictures with all the wires connected?

[fruity]

Hi, I don't see the pic here, have you post it ?

Try again. The picture upload utility was being flaky and limiting.

I removed all the wires because it wasn't working.

I tried the wires on my first Mightyboard the way that I was told to in this forum thread. And then I bought another board and I tried them the opposite way! Mind you, this is on a brand new power supply, straight from the original manufacturer.

If there is a way I can replace a capacitor or two and have a working board that would be great. Right now I am unsatisfied with Geeetech's product and am hesitant about buying a new board to try again.

I have two brand new OEM 12 V power supplies in addition to the Jameco 24 V power supply. I have two fried Geeetech Rev E boards and I have one broken original from Makerbot.

[Mark]

How about the chip here as the pic shows? It might be dead under24V. I'll contact you to solve this.