Info Ramps-FD V1a and DRV8825 DRIVER

[saviothecnic]

Good Evening

I have no movement of motors and read the wrong temperature

Use Ramps FD V1a Arduino TWO and Drivers 8825
I verificarer if the Jumpers and the drivers are installed correctly
Place two photos.

Thank You

In Ialiano
Buona Sera

Non ho movimento di motori e leggo temperatura sbagliata

Uso Ramps FD V1a Arduino DUE e Drivers 8825
Mi verificarer se i Jumper e i drivers sono montati in modo corretto
Posto due foto.

Grazie

[Mark]

Hi,saviothecnic .According to your pic ,I think 3 of your drivers were wrong installed, they should be like this:

[saviothecnic]

Ok Thanks indeed there tava an arrow pointing to Enable and I have noticed

Now unfortunately shot two DRV 8225 were burned but otherwise everything OK

Now I have another problem on temperature probes They read semrpe always up 140 ° C

[Mark]

How about the read at a room temperature ? Please check if somewhere of the thermistor sensor wire are bad connected.

[saviothecnic]

The sensor is OK because if I try on Ramps 1.4 reads well

[saviothecnic]

You can attach your firmware you use on your RampsFD
So I check that my problem is a FW or nature HW
My problem is that I can not read the temperature read and hotheaded