Y- Axis Failing

jfsgi · Post by **jfsgi** » Mon Jun 15, 2015 9:37 am

I got the error while trying to upload the firmware>

I loaded the .ino file into the software and clicked upload. (I think there was a total of 73 files that loaded in the Arudiono for the upload

zhangxueyou · Post by **zhangxueyou** » Mon Jun 15, 2015 9:48 am

No, drag all the files into Arduino.

jfsgi · Post by **jfsgi** » Mon Jun 15, 2015 11:08 am

All of the files are loaded into audrinio, 73 total

zhangxueyou · Post by **zhangxueyou** » Mon Jun 15, 2015 11:28 am

Still displaying error? What version of Arduino are you using?

jfsgi · Post by **jfsgi** » Mon Jun 15, 2015 7:29 pm

1.6.4

zhangxueyou · Post by **zhangxueyou** » Tue Jun 16, 2015 9:12 am

Higher version doesn't have good compatibility, you can try to upload with Arduino1.0.1:
http://arduino.googlecode.com/files/ard ... indows.zip

jfsgi · Post by **jfsgi** » Tue Jun 16, 2015 9:20 am

Loading via the lower version seemed to work,

I also have a problem with the slicer

I attached a photo of the issue

Please advise

zhangxueyou · Post by **zhangxueyou** » Tue Jun 16, 2015 9:29 am

You can refer to this page to set your printer in Repetier first:
http://www.geeetech.com/forum/viewtopic ... 21&t=16512

Geeetech

Y- Axis Failing

Re: Y- Axis Failing

Re: Y- Axis Failing

Re: Y- Axis Failing

Re: Y- Axis Failing

Re: Y- Axis Failing

Re: Y- Axis Failing

Re: Y- Axis Failing

Re: Y- Axis Failing