calibrating

Post Reply
John LaBaff
Posts: 7
Joined: Tue Apr 07, 2015 10:01 am

calibrating

Post by John LaBaff » Thu Apr 23, 2015 7:26 pm

Ok I have my printer setup and ready to run. How do you set home positions. Also when I tried to start a print the x axis goes to the left and start to make a grinding noise please help
Top
tonyflrb
Posts: 1
Joined: Sun Jun 14, 2015 8:03 am

Re: calibrating

Post by tonyflrb » Sun Jun 14, 2015 8:17 am

I also finished to assembly the printer, and has the same question. so every time I want to print something, do I need to reposition Z-axis?
because it is really time consuming if I have it all the way up!!
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: calibrating

Post by zhangxueyou » Mon Jun 15, 2015 9:12 am

tonyflrb wrote:I also finished to assembly the printer, and has the same question. so every time I want to print something, do I need to reposition Z-axis?
because it is really time consuming if I have it all the way up!!
Normally, you don't need to reposition z axis. How do you calibrate the distance between nozzle and glass?
Does the height of hot bed lower itself when you are heating the bed?
Top
Post Reply

Return to “Control Board”