Y Axis Problem

[3DPO]

here it is

[zhangxueyou]

Oh, your board type is GT2560. There's no jumper cap.
Then you should check if the printing model is amplified on y direction.

[3DPO]

can you tell me how I do that?

[3DPO]

model always look regular in repetier host.

[zhangxueyou]

Look at the picture, but please make sure all the switches under A4988 are on. The picture you show me is Z motor.
And please make sure the red wire of fan should be connected to "+", otherwise the fan will be dead.

QQ截图20150507084251.png (22.46 KiB) Viewed 9819 times

[3DPO]

all the switches are on and the fan is plugged in. Please see the attached gcode and photo, scale of everything is set to 1. I did try setting the Y-axis to 0.25 which brought the print close to correct size. Can you tell me how to fix this?

[zhangxueyou]

Sorry, but you forgot to upload the g-code file. If you can not upload, you should add it into a zip.

[3DPO]

here it is

[zhangxueyou]

Please tell me the values of "X-steps/mm" "Y-steps/mm" and "Z-steps/mm" on LCD:
Control>Motion>Y-steps/mm

[3DPO]

see photo