Ramps 1.4 Mosfet Overheating "magic smoke"

Post Reply
dodonash
Posts: 2
Joined: Sat May 02, 2015 4:26 am

Re: Ramps 1.4 Mosfet Overheating "magic smoke"

Post by dodonash » Mon May 04, 2015 6:12 pm

i have pay a Geeetech Premium Prusa i3 Kit and i assmply it and it work but after i work 5 time the ramps 1.4 is burn and the bed heat is heting without stop what i can do
Attachments
0003.jpg
frant
0003.jpg (159.89 KiB) Viewed 5945 times
0001.jpg
frant
0001.jpg (184.35 KiB) Viewed 5945 times
0002.jpg
back
0002.jpg (174.99 KiB) Viewed 5945 times
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Ramps 1.4 Mosfet Overheating "magic smoke"

Post by zhangxueyou » Tue May 05, 2015 10:52 am

Obviously, bad cooling cause burning.
Top
Post Reply

Return to “Control Board”