Ramps-FD v1a

campe89 · Post by **campe89** » Mon Apr 13, 2015 6:06 pm

Hi, I've just received the board+iduino due from an ebay reseller.
Unfortunately, the board version is the 1a; I have try the board with a porting of Marlin firmware but there are many problems:
-random disconnection from repetier-host
-only X min endstop work
-when I start the print, the movements are uncontrolled and stop after few seconds

Can be a problem of the board? firmware? else?
My system is based on windows 7 x64 with repetier-host 1.0.6

Thanks.

zhangxueyou · Post by **zhangxueyou** » Wed Apr 15, 2015 4:32 pm

Please check if the status of endstops are correct in firmware.

saviothecnic · Post by **saviothecnic** » Thu Aug 06, 2015 2:04 pm

Also I'm having a lot of problems with this card

For switches I solved it seems that the word min max is reversed
It must be enabled by FW resistance PollUP

I have a big problem I go thermistors are 100k
Ramps on 1.4 work on ramps FD-1a I always read 140 ° C

Mark · Post by **Mark** » Fri Aug 07, 2015 11:52 am

Hi,saviothecnic.
I think your firmware is the wrong edition,can you tell me what your printer type is and your mainboard ,see I could find the right firmware for you.

saviothecnic · Post by **saviothecnic** » Fri Aug 07, 2015 2:31 pm

I have a card-FD Ramps v1a with ArduinoDUE

Printer type Cartesian type Prusa I3

FW Used Marlin4Due portring Kimba http://marlinkimbra.it/

I also tried RepiterFirmware
but I prefer to Marlin

I include photos of my current installation

Thank you

Mark · Post by **Mark** » Fri Aug 07, 2015 4:37 pm

sorry，I do not have the firmware you want...

saviothecnic · Post by **saviothecnic** » Fri Aug 07, 2015 5:13 pm

You can attach what you are using now?
so I check if loaded on my card works all
and especially the temperature sensor

Geeetech

Ramps-FD v1a

Ramps-FD v1a

Re: Ramps-FD v1a

Re: Ramps-FD v1a

Re: Ramps-FD v1a

Re: Ramps-FD v1a

Re: Ramps-FD v1a

Re: Ramps-FD v1a