Pitting , Hole , Defect on printing

[begizmo]

Hi
I just test stl file
1. cubic 15 mm^3 , I take a photo as attached

FullSizeRender (41).jpg (63.97 KiB) Viewed 15911 times

FullSizeRender (42).jpg (71.34 KiB) Viewed 15911 times

FullSizeRender (43).jpg (64.44 KiB) Viewed 15911 times

FullSizeRender (44).jpg (56.81 KiB) Viewed 15911 times

this cubic has distort in Y-Z axis (look slope but truly must vertical )
How I fix or setting this ?

2. I test many file some of them it occure on first layer
The problem is first layer not attach with hot bed in some area ( especially on the corner )
so on the next layer will make bad print .

FullSizeRender (46).jpg (61.93 KiB) Viewed 15911 times

How i fix this ?


Thank

[begizmo]

Hi All
I just test Batman as image I attached
You will see some big pitting , hole
How can i improve this surface to better ?
Why this occure ?


Thank in advance
Theo

[zhangxueyou]

Decrease the layer height (except first layer), there will be less holes or even no hole.
As for the sharp part: When printing the sharp part, you should lower the printing speed.
But when printing the top, it can't print perfectly because its area is too small that the nozzle melt the printed part.

[begizmo]

THank sir ^^

[begizmo]

Hi
I just many test
I still have problem of hole
1. Like this picture

FullSizeRender (55).jpg (80.88 KiB) Viewed 16044 times

2. For first layer and 2,3,4,... It is not smoth , and many problem like this

FullSizeRender (54).jpg (55.09 KiB) Viewed 16044 times

Could you suggest me ?

Thank you
Theo

[zhangxueyou]

How about other parameters of slicer settings? Could you please give me some screenshots.

[begizmo]

This is my setting ^^

l1.png (54.94 KiB) Viewed 16038 times

l2.png (15.77 KiB) Viewed 16038 times

l3.png (19.82 KiB) Viewed 16038 times

l4.png (7.26 KiB) Viewed 16038 times

l5.png (14.83 KiB) Viewed 16038 times

l6.png (50.02 KiB) Viewed 16038 times

[zhangxueyou]

Fill density is too high, lower it to 25%.
Extruder width of first layer is all too high, lower it to 200%.
Please tell me Estep displayed on LCD . (Control>Motion>Esteps/mm)

[begizmo]

In LCD Estep/mm +0095.0

[zhangxueyou]

I will try to print a model with your slicer settings. You changed so many parameters. And I will tell you how is my model with your slicer settings.