Printing Quality

leonardo.galardi@gmail.com · Post by **leonardo.galardi@gmail.com** » Tue Mar 24, 2015 2:41 pm

Hi,
I mean for layer height = 0.1 mm.
I've attached now the results that I forgot in my previous post

zhangxueyou · Post by **zhangxueyou** » Tue Mar 24, 2015 2:44 pm

Usually, the first layer height equal nozzle diameter.
You can see more details at this page:
http://manual.slic3r.org/

Khilborn · Post by **Khilborn** » Tue Apr 21, 2015 11:44 pm

I redid my entire calibration of the XYZ and I am still having a problem printing a test cube.

It looks like the problem is on the x-axis. The pulley's are tights and the belts are as tight as I can make them without them causing the extruder to start skipping.

zhangxueyou · Post by **zhangxueyou** » Wed Apr 22, 2015 9:37 am

Perhaps the filament does not stick to hotbed. Please try to smear a layer of glue, or spray a layer of hair sprayer.

Geeetech

Printing Quality

Re: Printing Quality

Re: Printing Quality

Re: Printing Quality

Re: Printing Quality