Assemble the X-Z axis Problem

[begizmo]

Hi All
I just assembly 3d as following link
http://geeetech.com/wiki/index.php/Acry ... ction(8mm)
I have problem in X-Z axis problem when I assemble Z-axis top mount ( NO.A8 )
It can't rotate Z-axis ( look like it is not smooth )
I try to don't cover Z-axis top mount on them and power on .Every motor can run good.
but when cover Z-axis top mount it can't rotate .

Do you have any recommend to fix this case ?
Thank you
Theo

FullSizeRender (37).jpg (129.56 KiB) Viewed 14168 times

FullSizeRender (38).jpg (112.47 KiB) Viewed 14168 times

[zhangxueyou]

Maybe you have not tightened the couplings. Please tighten them.
Rotate the screws as shown in the pictures:

QQ截图20150317180515.png (491.28 KiB) Viewed 14165 times

QQ截图20150317180453.png (626.7 KiB) Viewed 14165 times

[begizmo]

Thank zhangxueyou
I just tighten 4 of them ( 2 sides)
I look better but I still stuck when I cover X-Z and turn on motor.
I try to turn by hand , it is very hard to rotate on one side and another side can easy to rotate

Do you have any more sugguest

Thank

[Dominique]

Hello,
j'ai eu le même problème, résolu en mettant un morceau de feuille d'aluminium autour de la tige filetée pour serrer mieux.
désolé mais je ne sais pas l'expliquer en anglais, try with Google traduction

Best regards
Dominique

[szeiger]

I had to enlarge the holes in the top plate for the threaded rods as the hole is the wrong diameter for free movement.

[zhangxueyou]

Hi, begizmo
Firstly, you should make sure the assemble direction of pulley is correct. Look at the picture below:

QQ图片20150318095536.png (217.74 KiB) Viewed 14138 times

Secondly, as you can see in the picture, the section of the shaft of the motor is not circle, there is a flat side. So you should correcly assemble it to the pulley(Look at the hole of pulley carefully). One screw on the pulley should be aligned the flat side. Tighten all the screws.

initpintu_副本.jpg (76.94 KiB) Viewed 14138 times

Hope will help you.

[zhangxueyou]

Hi, Dominique
Vous ne avez pas besoin de résoudre le problème de l'aluminium. Vous pouvez voir la flèche dans le dessin-il? Serrez les trois vis.
Je espère que vous pouvez résoudre le problème.
Je utilise la traduction de Google. Je espère que vous pouvez comprendre.
bonne chance.

[zhangxueyou]

Hi, szeiger
I am sorry for your wasting time on enlarging the hole. We narrow the hole to avoid the deviation formed by the rod, 99.9% of the which are eligible.

[begizmo]

Thank zhangxueyou, Dominique, szeiger
I can solve this problem by Drill the hole a little bit for smother and it can easily to rotate

Thank again for all

[Dominique]

Hello,
there is not screews on the back

Dominique