MeCreator firmware

[sierrab]

Is there MeCreator firmware somewhere available for download? I've tried using newest marlin but it has too much configurations needing adjusting for mecreator (extruder temps are off etc...). I just needed to invert my extruder direction.

[Admin]

Could you please tell me your mainboard type?

[sierrab]

Where can i check my mainboard? Printer is basic MeCreator bought from dx.com. I think it has newest Sanguinololu board.

[sierrab]

Please could i have firmware for Me Creator . My email is sierrabar@hotmail.com

[Admin]

Please take a picture

[sierrab]

Ok. Heres pictures of the board and the printer itself.

My printer was working just fine until extruder motor stopped working completely. All it was doing was small back and forward movement, not extruding at all.
I ordered new motor for extruder from geetech but it came with different wire order.
Also new motor wouldnt work either with old wire, but with the new wire (witch has different wire order) that came along with motor it was working but in the wrong way.

If i could just have firmware i could invert extrusion direction and i think it would be working again.

[zhangxueyou]

Please check your email.

[sierrab]

Thanks. Im sure it will. I will test it tomorrow.

[JustSomeGuy]

I have the exact same printer in the pictures. Sanguinololu board. Please email to justsomeguy45678@gmail.com. Thanks.

[ooi888]

I have the exact same printer in the pictures. Sanguinololu board. Please email to ooi888 (at) gmail.com. Thanks.