Prusa i3 with Iduino Mega 2560 + lcd 2004

[saxomophone]

Hello! Just recieved the prusa i3 kit with Iduino Mega 2560 + RAMPS 1.4 board and lcd 2004.
I can't seem to find the wiring scheme for the electronics and extruder anywhere! Supplied on you
website is only the mounting instructions for the mechanical parts. I saw i a earlier post that
someone got the wiring instructions mailed to him, can i have the instructions too please?

email: fladerbacken01@gmail.com

[saxomophone]

after a closer look at all the parts it seems to br straight forward so i think i'll manage, also found the ramps page on your wiki. Bad searching from my side

[techsupport]

Hi saxomophone
Please refer to the following link. the electronic parts connect.
http://www.geeetech.com/wiki/index.php/Ramps1.4
The appended drawings have a clear connection.thank you.
Best regards!

[saxomophone]

Hello again. I have now started with the electronics, and it doesn't seem to be a thermistor for the heatbed included in the kit. On the heatbed is two smd leds and a smd resistor pre-soldered. Is the thermistor missing from my package or is it so that the heatbed-thermistor is an smd-version already soldered on the heatbed, and if so: how is the wiring for the heatbed?
Regards!

[techsupport]

Dear saaxomphone
sorry to late reply, Because thermistor is small, not easy to find, you check your package carefully and the ground.
If you still can't find, you can send a picture of your packaging, we will give you a satisfactory answer.
waiting for your repely, thank you. Best regards!

[saxomophone]

Hello. I've thoroughly searched the package and the thermistor is definitely
not there, but i found that an electronics-shop near my home have equivalent thermistors in stock
so i've got some from there. Regards.