Geeetech a30 Not extruding filament

Post Reply
gorakwedi
Posts: 1
Joined: Thu Aug 11, 2022 7:39 pm

Geeetech a30 Not extruding filament

Post by gorakwedi » Thu Aug 11, 2022 9:04 pm

Feeder is Not pushing the filament

Hi guys. I have a little problem with my 3d printer. When i‘m loading or unloading new fillament the printer pushes it fine through the tube. But when i start a print the filament doesn‘t move anymore. The Motor with the gear is rotating but the feeder wheel is standing still. Any suggestions? Ps the Printer is a Geeetech A30.
Top
Post Reply

Return to “Geeetech A30 Series”