Make a Big 3D Printer at Home Using Arduino

Post Reply
Adel123
Posts: 4
Joined: Sat Oct 23, 2021 4:49 pm

Make a Big 3D Printer at Home Using Arduino

Post by Adel123 » Mon Oct 25, 2021 10:33 am

I am interested in DIYing a 3d Printer at home. This is my first to start a project. Firstly, I need to calculate what materials, components and supplies
are needed? This is the Electrical Components Required.
    Arduino Mega 2560 x 01 Nos.(datsheet)
      Ramps 1.4 controller board x 01 Nos.
        Optical endstop switch x 03 Nos.
          NEMA 17 stepper motor x 05 Nos.
            PCB heatbed x 04 Nos.
              E3D v6 hotend x 01 Nos.
                A4988 stepper motor driver x 04 Nos.
                  Power supply 12V/20A x 01 Nos.
                    ATMEGA16U2 Microcontroller(datasheet)
                    Is that all? I am not sure.Thanks for you sharing your advice
                    Top
                    Post Reply

                    Return to “Control Board”