Weird problem with bltouch

[bakelmion]

I have a geeetech a10 and have gotten a couple upgrades for it but. I’m having an issue with the z axis raising after I use auto home then level corner the z axis raises 3mm or so and no longer gets close to the bed. I can do a video of it later while I’m not at work. But is strange didn’t happen after I put bltouch on but after 4 prints with having bltouch it started doing this and now I can print or do shit with it. I’ve re flashed it a couple times reset all settings in the printer back to factory took the bltouch off and it still does it after I level the corners. I’m lost here.192.168.0.1 router login 192.168.1.1