Hello everyone,,
I'm new to 3D printing. I got a Geeetech A10 and set it up, hopefully correctly. Each time I print the test print (supposedly a dog), the print head scrapes off the first layer as it moves around https://100001.onl/ https://1921681254.mx/. I've done the paper test, and I thought it was correct but maybe not. Any ideas how to fix this?
Geeetech A10 first time problems
Geeetech A10 first time problems
Last edited by Kabutoo on Sat Aug 21, 2021 9:12 pm, edited 2 times in total.
Re: Geeetech A10 first time problems
Hello, maybe your printing first layer is not completely stuck? Please try to increase the temperature of the lower hot bed to 5-10°C to see if the first layer of consumables can be completely stuck.