Print Slanted on the Y Axis

NightStorm1000 · Post by **NightStorm1000** » Sat Jan 13, 2018 2:15 am

Hi!

I recently build my I3 Or and noticed something

My Prints come out slanted on the Y Axis

Any Idea?

Here is a Picture

https://www.dropbox.com/s/5zaqnype7wioa ... 5.jpg?dl=0

Post by **William** » Wed Jan 17, 2018 7:59 pm

1.Check the belt of Y axis

2.Increase the voltage of Y-axis driver board A4988

: ADJUST.png (206.02 KiB) Viewed 22518 times

3.Adjust the tight of Y-axis screw

: Y motor.png (839.18 KiB) Viewed 22518 times

NightStorm1000 · Post by **NightStorm1000** » Wed Jan 24, 2018 5:05 am

Adjusting Acceleration, Jerk and Steps fixed it.
Thanks anyway!

USMCPelto · Post by **USMCPelto** » Thu Sep 17, 2020 4:00 am

How did you adjust those parameters?

mlauber · Post by **mlauber** » Sat May 15, 2021 10:09 pm

NightStorm1000 wrote: ↑
Wed Jan 24, 2018 5:05 am
Adjusting Acceleration, Jerk and Steps fixed it.
Thanks anyway!

Yeah seriously, how did you adjust those settings? I can see them on the screen but I haven't figured out how to change them at all.

: IMG_20210512_170029.jpg (181.5 KiB) Viewed 8250 times

core2k · Post by **core2k** » Sat May 29, 2021 2:31 am

If you are using Cura you are able to change those settings directly in the slicer! Think cura is the only slicer atm that support that feature.
Otherwise you have to change those settings in your firmware.

Geeetech

Print Slanted on the Y Axis

Print Slanted on the Y Axis

Re: Print Slanted on the Y Axis

Re: Print Slanted on the Y Axis

Re: Print Slanted on the Y Axis

Re: Print Slanted on the Y Axis

Re: Print Slanted on the Y Axis