Hi all
I have installed my first roll of filament and I cannot get a decent print
I have an A20T and bought some EONO filament from Amazon
I use cura slicer.
Where have I gone wrong?
Where have I gone wrong?
- Attachments
-
- 20210329_142246.jpg (341.53 KiB) Viewed 4524 times
-
- 20210329_142226.jpg (291.62 KiB) Viewed 4524 times
-
- 20210329_142208.jpg (220.52 KiB) Viewed 4524 times
-
- 20210329_142124.jpg (298.36 KiB) Viewed 4524 times
Neil
Re: Where have I gone wrong?
Hello, you can try to print the object below. It may be a problem with your Cura settings, depending on the printing effect.
- Attachments
-
- cube.rar
- (116.75 KiB) Downloaded 360 times
Re: Where have I gone wrong?
Thank you, I will give it a go.
I have persevered with it and got the quality as in the pictures, however i am now experiencing layer separation on the last 4 outer layers, but the rest of the print looks ok.
I apologise for the delay in coming back to you you
I have just downloaded the Easyprint lite Beta from the downloads section to see if that makes a difference, but there is very little documents about changing setting. (i have watched the videos about colour mixing)
Neil
I have persevered with it and got the quality as in the pictures, however i am now experiencing layer separation on the last 4 outer layers, but the rest of the print looks ok.
I apologise for the delay in coming back to you you
I have just downloaded the Easyprint lite Beta from the downloads section to see if that makes a difference, but there is very little documents about changing setting. (i have watched the videos about colour mixing)
Neil
- Attachments
-
- 20210406_102634.jpg (20.82 KiB) Viewed 4282 times
-
- 20210406_102838.jpg (20.73 KiB) Viewed 4282 times
Neil