I recently bought a A10 pro and am a bit at a loss on how to screw in the included filament sensor.
If I screw it in on top of the extruder bracket it seems to be too high up, as well as it looks as if the screw heads will collide with the filament.
If I screw it underneath ... well the sensor has a wide flat side and a side where it sticks up ... so it seems illogical to put that side against the bracket and have the flat side dangling in the air ...
And If I would screw it on underneath with the flat side against the bracket the sensor would face below the extruder ...
Yeah ...
Noob question->A10 pro, included filament sensor.
-
trainwreck
- Posts: 1
- Joined: Wed Oct 14, 2020 8:38 pm
Re: Noob question->A10 pro, included filament sensor.
Bonjour,
voici comment je l'ai mis :
voici comment je l'ai mis :
- IMG215424.jpg (215.48 KiB) Viewed 2644 times