update gt 2650 v4 marlin to tmc2208

[avivhl789]

hi there , I just replace a4998 with tmc2208 but couldn't find any marlin with gt 2650 v4 for a20m all are v3. some help will be welcome.

[gopher]

Source code for v4 is the same as v3. I've already installed tmc2208 on my v4 and all is ok. But don't forget, that if 2208 is on extruder, you shouldn't activate linear advance!

[avivhl789]

Source code for v4 is the same as v3. I've already installed tmc2208 on my v4 and all is ok. But don't forget, that if 2208 is on extruder, you shouldn't activate linear advance!

on the extruder it still a4998. tank u for the reminder. can u share your merlin?

[gopher]

Yes, i'll attach it to this reply.
You should carefully check Start_here.h - attached source code is configured for my a10 with gt2560 v4, but there is guide in the comments)

Marlin-B495_a10.rar

(3.18 MiB) Downloaded 339 times