Faulty power plug

[tbs_dk]

Had an issue where i got home to failed print and after i removed everything and wanted to start over i found that the bed would not heat up.
Then i had a closer look at the board and found that the PSU plug was all burned on one of the 12volt rails.

now i have to locate new plugs and solder a new one on to the board and hope nothing is fried.

But i cannot understand why / how this could have happend as the plug on the board and the cord are something what i made form the factory and not something you have to assemble your self.

And also just happy that it did not end i something worse like a fire..

IMG_20200611_164329.jpg (249.37 KiB) Viewed 14291 times

IMG_20200611_164322.jpg (329.57 KiB) Viewed 14291 times

[William]

Hello, sorry for this situation, you can contact the salesperson to replace the line and motherboard.

[tbs_dk]

HI

Thanks i will try. But as i bought this printer from a 3rd party and not directly from Geeetech i am not sure that Geeetech would replace the board.

And its not just the board its also the cable from the PSU that have the male end of the plug.

[William]

Hello, you can consult customer service on the purchase platform.
Under normal circumstances, the seller will also deal with after-sales.