Hi!
I reinstalled the firmware 1.1.8 and now i can't control the filament cooling fan. It is always ON.
The fan start when i power on the printer and stop when i turn off the printer.
It is not possible to stop or change it neither from lcd od Cura.
Why?
Please,anyone can help me?
Thank you very much!!
Fan problem
Re: Fan problem
Hi，are you referring to this fan? If this fan cannot be controlled, you need to replace the motherboard.
- QQ图片20200525100450.png (30.16 KiB) Viewed 2295 times
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!