A30 Extruder Caliberation

156801 · Post by **156801** » Mon Apr 27, 2020 5:40 pm

Hi,

can someone please explain how to extrude 100 mm of filament so I can calibrate the extruder?

I can not see anything on the touch screen to do it.

Thanks

Robert

Post by **William** » Tue Apr 28, 2020 10:18 am

Hi，you can set the nozzle temperature to the target temperature (190 ~ 210 ℃) when printing PLA consumables. After the temperature is stable, operate the extruder feed on the touch screen.
as the picture shows.
The extruder will automatically feed until the nozzle has molten filament extruded. Select E0, E1, E2 extruder feed in sequence.

: QQ图片20200428101746.png (17.92 KiB) Viewed 5488 times

: QQ图片20200428101757.png (20.41 KiB) Viewed 5488 times

156801 · Post by **156801** » Tue Apr 28, 2020 8:04 pm

Hi Willian,
Thanks for the reply.

I tried what you suggested but it just kept extruding it did not stop at 100 mm. The touch screen display looks different.

Firmware is V1.35.56

Robert

Post by **William** » Mon May 04, 2020 4:04 pm

Hi，stop heating consumables will not melt again, if there is still a part of the outflow is normal, it has been heated and melted in the hot end. You can try printing to see the effect.

Geeetech

A30 Extruder Caliberation

A30 Extruder Caliberation

Re: A30 Extruder Caliberation

Re: A30 Extruder Caliberation

Re: A30 Extruder Caliberation