EasyPrint

[Miktian]

Good afternoon, inserting a model with the .stl extension
, I click the slicer button processing begins and the program closes in seconds, despite the fact that in version 1.0.17 everything was fine and in the new 1.2.6 it turns out like this. How to fix this problem?

[William]

Hi，my friend.
Can you provide the model and picture?

[Miktian]

Hi，my friend.
Can you provide the model and picture?

Tried with different models as created by mnob, and downloaded from the Internet, as well as standard 2 pieces that give also does not convert. despite the fact that I translated and printed my model until I upgraded to the new version.

[Miktian]

Hi，my friend.
Can you provide the model and picture?

I don't know how screenshots will help you find the problem, but here)) Maybe the problem is a lack of Windows components to work with the program?? https://yadi.sk/i/v4p-sZBcLMgzVQ https://yadi.sk/i/5ahZxSdUHzqKHg https://yadi.sk/i/Ua9zoiPoniK5vA

[William]

Maybe you need to download the corresponding configuration file.

[Miktian]

Maybe you need to download the corresponding configuration file.

Those that go by the standard with the program do not work as expected??

[William]

Hi，it is recommended that you use other slicing software such as Repetier-Host or cura.

[Miktian]

Hi，it is recommended that you use other slicing software such as Repetier-Host or cura.

It seems like through Slic3r it turned out to achieve normal slicing. Small models printed perfectly, I check on the large one.