About how to connect the 3d touch

[William]

Hi, The specific insertion method is 3pin brown wire on, 2pin black wire on.
you can refer to this:

3d touch接线参考.png (140.09 KiB) Viewed 23446 times

[lmcmulle]

orange on top and black on top is the working config

[duglas]

So, i can't make it work following all your discussion. could you please write down a step by step procedure on where connect the wires, with a picture (that will be one among all the others) and links on the procedures to update-setup the program of the 3d printer and make it work (calibration).

thanks

[Chany]

Bonjour,

Je viens d'acheter donc cette fameuse Geeetech A20T avec le 3D touch.
Ou se trouve le firmware avec le 3D touch pour cette imprimante. Je ne le trouve pas....


Merci

[William]

Hi, the firmware with 3d touch is still being tested.
It will be uploaded after the test.

[Fredoooo]

Des news concernant le firmware 3d Touch pour la A20T??

[William]

Des news concernant le firmware 3d Touch pour la A20T??

Hi,you can select the corresponding model to download on the download page of the official website.
You can refer to:viewtopic.php?f=20&t=70221