A10M E0 Extruder Cable Change
-
Prapatsorn_Lert
- Posts: 1
- Joined: Sat Jan 25, 2020 3:29 am
A10M E0 Extruder Cable Change
Hi, I'm having a problem with the E0 motor and figure that it might be because of the cable. Both extruder motors work fine when plugged with E1 cable, but both didn't work when plugged with E0 cable. I tried to change the cable, but cannot remove the female pin from the connector. Is there anyway to fix this?
- Attachments
-
- I need to remove these four pins
- InkedIMG_20200229_165526_LI.jpg (231.87 KiB) Viewed 2497 times
-
- I need to remove these four pins
- InkedIMG_20200229_162119_LI.jpg (212.59 KiB) Viewed 2497 times
Re: A10M E0 Extruder Cable Change
Hi,You can try swapping the wires on the motor side to determine the problem, there is no need to change the wiring position on the motherboard side.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!