Any revisions on Y axis for GT2560 v3?

[millenium7]

I received a replacement board for my A10M after waiting a very long time. I installed and connected everything up and flashed firmware that I had on there before (all setup the way I want it, was working perfectly), everything works except for the Y axis, it doesn't move at all

I tried swapping the stepper drives on X and Y. X works fine (so the stepper is good) but Y does not move
Tried swapping the motor connectors around. X moves the Y axis fine, so the cable and the motor are good. Trying to move Y does nothing

So either the pinout has changed, or I need to do something different for the Y axis, or I have yet another dead board. If the latter i'm NOT happy as I waited ages for this board and paid nearly 3x as much as a SKR1.3 which is a better board in just about every way

[William]

Hi，You can try swapping motor lines (not the position of the motor port).

[millenium7]

Already tried that. It's definitely a problem with the Y axis

I've gotten no reply from Geeetech so i'm just going to have to look at it carefully, maybe i'll see a broken solder joint or something and can repair it

[William]

Hi，If it is caused by the broken motor wire of the y-axis, you can contact your sales instructions.