I print the same g code 3 times 1 is good 2 failed at different layer heights.
I tested to print with SD card same sometimes it work sometimes not.
But my extruder motor is really hot... I think over 70°C.
Drucker wirft während Druck Filament aus
-
Vlad_dracul
- Posts: 8
- Joined: Sat Jan 18, 2020 4:18 pm
-
Vlad_dracul
- Posts: 8
- Joined: Sat Jan 18, 2020 4:18 pm
Re: Drucker wirft während Druck Filament aus
How I can use Marlin?
Re: Drucker wirft während Druck Filament aus
Hi, If you print for a long time,The electric machine has overheated,
You can print in a well-ventilated area,
Or make appropriate adjustments to the drive board voltage.
Can the test files in the SD card be printed normally?
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
Vlad_dracul
- Posts: 8
- Joined: Sat Jan 18, 2020 4:18 pm
Re: Drucker wirft während Druck Filament aus
Where the Printer stay it have 19°C.
The Extruder driver runs with 0,5 V. How low can i adjust?
Yes, short prints runs well.
All about 3 Hours are high risk.
The Extruder driver runs with 0,5 V. How low can i adjust?
Yes, short prints runs well.
All about 3 Hours are high risk.