Hi,
I have a Geeetech A10M. I am using Cura 4.4 printing slicer. I change the values to work with my Geeetech and everything works great except the prime tower. It start off great and then almost half way done the middle of the prime tower stop building right. You can see from the photo outside is great but the middle is not printing right. Please help . I love this slicer.
Prime Tower
Prime Tower
- Attachments
-
- IMG_20191229_113812.jpg (248.41 KiB) Viewed 4077 times
Re: Prime Tower
Did you render gcode? Is tower full or is broken in gcode?
Restart Cura, your OS... repeat slicing.... look at gcode.
Restart Cura, your OS... repeat slicing.... look at gcode.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Re: Prime Tower
Hi, You can view your configuration and re-slice it for printing.-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Prime Tower
Hi, You can try to reset it and slice it.-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!