Z axis limited to 100

[gabber]

Hi Everyone,
in my Geetech I3 alu, i never printed object taller than 100mm

When i try this morning, i see a limit a 100mm.

when i try to move more than 100 directly on" move panel" in printer, i can't go .

anyone now what setting i need to move to push the limit to 180?

It's a soft limit because when i change the step ratio, i can go to 180mm physicaly but under 100 in command.

[gabber]

ok, i fixed the problem.

with :

• arduino 1.01

• firmware:PI3_Sanguino

thanks for the fast reply