Hello
I have problem with cable connections marked "E"
I can't figure out where the connectors with 1 and 5 PINs should be put
Please someone can help me?
Thank you
A20 - connections
A20 - connections
- Attachments
-
- IMG_3194.JPG (241.24 KiB) Viewed 14351 times
Re: A20 - connections
Hi, You can check if your extruder motor is wired.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: A20 - connections
yes,
the extruded is wired with another connector
from the same cable there are :
connector for extruder
connector 5 PIN
connector 1 PIN
so, what I can do with 1 and 5 PIN ???
the extruded is wired with another connector
from the same cable there are :
connector for extruder
connector 5 PIN
connector 1 PIN
so, what I can do with 1 and 5 PIN ???