3D Touch Sensor:Auto-levelling

[dbelge]

Hello,

I have a simple question for the 3D touch sensor :

Did the correction be stored automaticaly after an auto-levelling? Or do we have to store the settings manualy? Or do we have to do the correction every time we switch on the printer?

Thanks in advance

[William]

Hi, After you calibrate your 3d touch, you need to save your changes.
You can refer to this: https://www.youtube.com/watch?v=_RtsZDbR2po

[dbelge]

And after an auto levelling?

[William]

And after an auto levelling?

Hi,If your 3dtouch can be used normally, it can be printed normally.