G2 pro - warn bearings in the link-arms

VikingHighlander · Post by **VikingHighlander** » Tue Nov 19, 2019 7:21 pm

Where can I get new bearings or complete arms for my Delta G2 pro?
Can I change only the ends with the bearings (with the screw/bolt into the axis-mounts and extruder-mount)?

Post by **William** » Wed Nov 20, 2019 9:29 am

Hi, you can provide a specific picture.

VikingHighlander · Post by **VikingHighlander** » Thu Nov 21, 2019 5:36 pm

: Arm_bearings.JPG (94.04 KiB) Viewed 18634 times

the ball-bearings at the ends of the arms holding the extruder & fan (which moves around when printing).
These seem to be worn. There is a little slack when I wiggle them.

Post by **William** » Thu Nov 21, 2019 5:46 pm

Hi, you refer to the: diagonal rod.

$`2PQ`}H[W@{Z4%Q3~VRP5_5.png$: `2PQ`}H[W@{Z4%Q3~VRP5_5.png (19.26 KiB) Viewed 18633 times

VikingHighlander · Post by **VikingHighlander** » Thu Nov 21, 2019 7:41 pm

yes. Can I buy new ones?

VikingHighlander · Post by **VikingHighlander** » Thu Nov 21, 2019 8:31 pm

Found another problem too.
the bearings in the pulley at the top of the y-axis belt was warn out too. see pic below.
I dont have the instructions/parts catalogue. The link to it on the forum was also dead.

can I have the pars number for this bearing aslo + a link to the instructions?

Do you sell the diagonal rods + pulley bearings?

: bearings pulley belt.JPG (114.24 KiB) Viewed 18631 times

Geeetech

G2 pro - warn bearings in the link-arms

G2 pro - warn bearings in the link-arms

Re: G2 pro - warn bearings in the link-arms

Re: G2 pro - warn bearings in the link-arms

Re: G2 pro - warn bearings in the link-arms

Re: G2 pro - warn bearings in the link-arms

Re: G2 pro - warn bearings in the link-arms